Upon completion of the course the student shall be able to safely perform all MCE® and EMAX tests and use the test results to evaluate the condition of a motor circuit. This course is intended both for technicians who perform testing and analyst who evaluate the results.
Course Terminal Objective
The student shall be able to safely perform all MCE® and EMAX tests.
Course Enabling Objectives
- EO 1 – List and describe the Six Fault Zones in an electric motor circuit, including which tests are used to determine the condition of each Fault Zone.
- EO 2 – Identify the equipment safety parameters.
- EO 3 – Describe the purpose and operation of all major hardware components and their
- EO 4 – Describe the purpose, operation, and major components of MCEGold® software during
- EO 5 – Describe all tests, including initial conditions, performance of the test, basic
interpretation of test results, and theory of motor operation as it applies to the test.
- EO 6 – Identify the conditions that may cause the tester to capture inaccurate or unusable data.
- EO 7 – Given results from specific tests, identify the most likely suspect/faulty motor circuit
component and the next troubleshooting step to be performed.
- EO 8 – Match applicable industry standards used by the tester to applicable tests.
- EO 9 – Describe the purpose and functions of the MCEGold Utilities Menu.
- EO 10 – Identify the proper methods for database management.
Introduction to MCEMAX® Course Format
- Day 1
The course begins with a classroom lecture and discussion on offline (de-energized) Motor Circuit Evaluation (MCE) using the six Fault Zones. Throughout the day students operate the tester using MCEGold to perform each of the MCE tests: AC Standard Test, Rotor Influence Check (RIC), Polarization Index, and Step Voltage Test. Students will perform a motor circuit analysis on both healthy and faulted motors using the collected MCE test results.
- Day 2
The students will participate in additional hands-on practice for MCE testing on de-energized equipment. The class will then continue with a classroom lecture and discussion on the use of the EMAX to perform AC motor Current Signature Analysis (CSA) and Power Analysis testing.
- Day 3
The students will perform hands-on AC motor EMAX testing under the direct supervision of the instructor. They will then analyze the collected data to evaluate the condition of healthy and faulted motors. Additional MCE testing may also be performed depending on the students’ request. At the end of the day there will be a detailed review of both MCE and EMAX AC motor testing and the Six Fault Zone approach to analyzing data collected by the MCEMAX.